Johan funny car

[Pat Minarick]

I have the quick change rear end out of the Johan funny car . Not sure what all the holes are for . I know the two on top are for mounts . But there is one on the drivers side bottom and two on the rear cover at the top . Have no idea what they are fore . Can anybody help me out ,  am I missing pieces?

I think the two in the rear cover may be wheelie bar mounts. 

Edited May 31, 2018 by Pat Minarick

[iBorg]

Top two holes are for part 21 (x2). Two holes on the back of the case are for wheelie supports. I'm not sure about the other holes on the bottom of the case, but I'd guess they're also for wheelie bars.

[Pat Minarick]

51 minutes ago, iBorg said:

Top two holes are for part 21 (x2). Two holes on the back of the case are for wheelie supports. I'm not sure about the other holes on the bottom of the case, but I'd guess they're also for wheelie bars.

Thanks,  that bottom one is the one I really can't figure out . It's only on the one side.

[tim boyd]

Here's a complete tutorial with 39 pictures on the Mustang/Pinto JoHan kit.  I don't know if this will help you or not, but thought I would offer it up anyway....good luck with your project.   TIM 

 

[Pat Minarick]

9 minutes ago, tim boyd said:

Here's a complete tutorial with 39 pictures on the Mustang/Pinto JoHan kit.  I don't know if this will help you or not, but thought I would offer it up anyway....good luck with your project.   TIM 

 

Thanks , that works . The hole that I wasn't sure about isn't on this one .  I will just fill it in . Thanks again.