Perfect Plastic putty texture

[R.D.F.]

I have a tube of this and to me it's on the dry side. Can I add a couple of drops of water in the tube to loosen the mix up a little ?

[Mike999]

Yep. I did exactly that when mine got old and started thickening in the tube, and I'm still using it. It's a water-based putty, not petroleum/solvent based. IIRC, I read the tip about adding water somewhere on this board.

ON EDIT: I found these tips about using Perfect Plastic Putty at the Hobbylinc web site:

"The putty is for filling small gaps, according to the label, but I have used it to mold small parts and add detail to existing parts.

Usually I build the putty up in layers, let it dry, sand and shape, then add another thin layer if needed. Once the desired shape is obtained, then the paint seems to soak into the bare putty, giving it strength and allowing a final sanding to a very smooth finish.

The putty will dry out on you quickly at the top of the tube and in the cap. When unstopping the neck of the tube, one has to make sure all the hardened pieces are removed or you will get streaked applications when trying to create a smooth surface."

Edited March 11, 2019 by Mike999
omit

[R.D.F.]

Mike thanks for your reply

[TomZ]

I often put a small drop of water in the tube when I am finished using it, if it seems like it is getting dry.