AMT Chevy Ii Drag Car

[cobraman]

Lowered a bit . Painted Tamiya black on the lower section and Tamiya Blue on the upper section . Cleared with Duplicolor 1K clear . Hate the tiny bucket seats that come in these kits and replaced it with a bench seat . Aftermarket decals were used . I screwed up the rear window and I was doing so well . ?

[Zippi]

Good looking Drag car.  I'm diggin it.  

[cobraman]

Thank you Bob .

[PappyD340]

Very cool Ray!

[unclescott58]

Very kool and mean looking Chevy II. I like it. 

[cobraman]

Thank you fellows.

[thatz4u]

nice work, Ray......I noticed it has no firewall..

[bisc63]

Very cool appearance. This kit may lack details, but does a lot right to make for the perfect drag car look. Your paint treatment is especially appropriate for an imposing drag car! The blackout treatment of the rear is so nice, I would have been tempted to carry it to the front as well. As far as those tiny buckets go, you should have posted in the "Wanted" here, as most of us have a trove of leftover buckets from our collective stashes! Your solution is perfectly fine, though. This is a cool hot rod all around. Well done.

[cobraman]

Thank you fellows.  Yes ,correct no firewall included in this series of AWB cars. Simple kits and not all that detailed.

[jphillips1970]

nicely done - now it's time to haul down to the drag strip and race - again, nicely done -

Joe

[cobraman]

Thank you Joe.

[fireguy14]

Very nice!