Bubbles in decals

[Bob Warfield]

I'm building a Fireball Roberts 64 Galaxy. I spent way too much time removing the chrome moldings and painting it. The body turned out real nice and I've been worried about decal installation, putting it off. Finally got nerve enough to try it today. The large #22 in the roof has a couple air bubbles under it.  Unfortunately I didn't notice them till to late. Any suggestions?

Thanks, Bob  

[stitchdup]

I put off decals for the same reason. When i did my escort i used decal solution and it went much better. you could try poking a hole in the bubble with a pin or fresh blade then use some decal solution on it. it should suck the decal down when it dries and the hole will let the air out